Tuesday, September 18, 2007
Saturday, September 15, 2007
What does it look like when we install a system?
This is a time lapse video of a 1 1/2 ton heat pump change out. This is a straight system replacement with little ductwork modifications, it will show you all the steps we take to install a system. We take care in preping our solder joints, pressure testing the system, sealing the ductwork and starting the system. This took 3 men 5 hrs to complete.
What does it look like when we install a system?
16 SEER Heat Pump
We've had a busy summer this year, the heat and humidity had us all jumping. Looking back at some jobs we did this summer I'd like to share some pictures of 16 SEER heat pump with an Accu Clean Air Filtration System we installed. The original system was 15 yrs old and used ductboard for the ductwork. We removed the old ductboard and installed new sealed and insulated metal ducwork. Take a look at the old ductboard, if you have ductwork that looks like this, consider giving us a call it may have some growth on the inside too.
Look at the growth on the inside of this ductboard.This is what ductboard looks like installed
The old air handler.
Here is the new air handler. Note the insulated and sealed ductwork on the left. The Accu Clean Filtration system is on the right. See the yellow wire with the black switch, that's a safety switch in the emergency drain pan. This will shut down the unit in case the unit should leak water.
Fall Savings
Check out our fall special!!! American Standard has teamed up with Marshall Mechanical to offer the following Fall Special. Check back next week to see how much you can save from oil to either gas or a heat pump!
Fall Savings
Subscribe to:
Posts (Atom)